Ping G410 SFT Fairway Wood (2019)

Availability:
In stores February 7th, 2019.

Available in stores only. Call for availability and fitting information today (208) 322-GOLF

Write a Review

Ping G410 SFT Fairway Wood (2019)

In the SFT model, more heel-side weighting and a lighter swing weight help square the face to create right-to-left shot bend (RH golfers). The heads are slightly larger to drive up the MOI, and lofts are 1.5° higher to promote easier launch. A forged, maraging-steel face increases ball speed and distance, and a new lightweight eight-position sleeve offers a wider range of loft (±1.5°) and lie combinations.

Larger Profile

The heads are slightly larger to drive up the MOI, and lofts are 1.5˚ higher than standard to promote easier launch. Sitting visually square at address, the SFT's profile inspires confidence.  

CG Aligned with Force Line

The low-back CG is slightly forward of G400 for faster ball speed with maximum stability and forgiveness. Impact occurs higher on the face, accelerating ball velocity with low spin for a long, penetrating ball flight.

Tungsten Weight, Forged Face

A high-density tungsten weight at the extreme perimeter of the head increase stability and forgiveness. The face is made of C300 maraging steel (one of the strongest alloys in the world), and is machined extremely thin to produce more flexing for increasing ball speeds, shot height and distance.

8-Lobe Trajectory Tuning

Trajectory Tuning 2.0 utilizes a new, patented lightweight and aerodynamic adjustable hosel with eight settings, offering loft (±1.5⁰) and lie adjustments, including up to 3⁰ flatter than standard, to optimize ball flight.

Specifications

Club

Loft

Loft Adjustability

Length

Average Lie Angle

Head Size

Swingweight

3-wood

16.0°degrees

±1.5°degrees

43"

56.5°degrees

188ccPing.Clubs.Specs.HeadSize.Units

D0

5-wood

19.0°degrees

±1.5°degrees

42 1/2" 1/2

57.0°degrees

177ccPing.Clubs.Specs.HeadSize.Units

D0

7-wood

22.0°degrees

±1.5°degrees

42"

57.5°degrees

167ccPing.Clubs.Specs.HeadSize.Units

D0

Notes

  • These are design specifications that may vary due to manufacturing tolerances.

  • Lie angle is an average of the five adjustable loft positions indicated on the hosel.

  • Swingweights with Mitsubishi Tensei and Project X EvenFlow shafts are 1 point higher than standard

  • Swingweights with Alta CB 65 Red SR & R flexes are 1 point lower than standard

  • Swingweights with Tour 65 R and Tour 75 R flexes are 1 point lower than standard